[. . . ] Sound and light Calc-Clean reminder -- After 1 to 3 months of use, the Calc-Clean light starts flashing and the appliance starts beeping to indicate that you have to perform the Calc-Clean process (Fig. -- You can continue steam ironing for 1 hour while the Calc-Clean light flashes and the appliance beeps. You have to perform the Calc-Clean process before you can continue steam ironing. €5) Tip:You can continue to dry iron by not pressing the steam trigger. [. . . ] Performing the Calc-Clean process with the Calc-Clean container Do not leave the appliance unattended during the Calc-Clean process. Caution: Do not interrupt the process by lifting the iron up from the Calc-Clean container, as hot water and steam will come out of the soleplate. Consult the separate quick start guide for instructions on how to detach the water tank (Fig. 2 Make sure that the appliance is plugged in and switched ON during the Calc-Clean process (Fig. 4 Place the Calc-Clean container on the ironing board or any other even, stable surface (Fig. note:The Calc-Clean container has been designed to collect scale particles and hot water during the Calc-Clean process. It is perfectly safe to rest the iron on this container during the entire process. 6 Press and hold the Calc-Clean button for 2 seconds until you hear short beeps (Fig. 7 During the Calc-Clean process, you hear short beeps and a pumping sound. Wait approximately 2 minutes for the appliance to complete the process (Fig. This happens automatically when the steam generator has not been used or the steam trigger has not been pressed for more than 15 minutes. Solution Set the on/off switch to ‘off ’ position and then to ‘on’ position. Fill the water tank with water and press the steam trigger until the pumping sound becomes softer and steam comes out of the soleplate. If the Calc-Clean light still flashes and the appliance still beeps, perform the Calc-Clean process (see chapter ‘IMPORTANT - Cleaning and maintenance’). You have to perform the Calc-Clean process again (see chapter ‘IMPORTANT - Cleaning and maintenance’). After the Calc-Clean process, remaining water may drip out of the soleplate. Impurities or chemicals present Perform the Calc-Clean process regularly in the water have deposited in (see chapter ‘IMPORTANT - Cleaning the steam vents and/or soleplate. You have accidentally started the Calc-Clean process (see chapter ‘IMPORTANT - Cleaning and maintenance’). Turn the temperature dial to the desired temperature setting instead of CÁLC CLEAN. Let the iron heat up until the ‘iron ready’ light lights up steadily. [. . . ] Turn the temperature dial to the desired temperature setting instead of CÁLC CLEAN. Let the iron heat up until the ‘iron ready’ light lights up steadily. You have not set the temperature dial to Calc-Clean or you have not waited for the iron to heat up. You have not pressed the CalcClean button for 2 seconds until the appliance started beeping. [. . . ]